Printable View
I want y'alls opinion on how you would cut the notches in PVC for an application like this. I want to be able to cut the V notches or angle notches the easiest way possible. Dremmel tool? Small Router? Any other ideas? Thanks
https://images-na.ssl-images-amazon....1EttwKTtgL.jpg
Circular saw. Doesn’t have to be pretty
Sent from my iPhone using Tapatalk
I would say if you had the tools, a piece of angled steel in a vise heated up red hot with a blow torch then push/melt it through.
I believe id use either the sawzall or angle grinder...
Multi-tool maybe ...Router would be ok but you will be covered with ...Maybe place Router table with blade up..instead freehanding...Like said above I agree hot steel would work great and easy
Use a miter saw. Set your angle to 45° and do one side of the V then set it to 45 ° and do the other. You can use a dremel to finish the end of the slots
Sent from my SM-J327P using Crappie.com Fishing mobile app
Maybe a end grinder and a bur bit
Sent from my moto z3 using Crappie.com Fishing mobile app
Drill pilot hole and then cut out with sabre saw
Sent from my VS995 using Crappie.com Fishing mobile app
That would work, maybe even 3 holes and just cut between them.Quote:
Originally Posted by Halfly
The trick will be getting both sides to line up just right, unless you oversize the holes to allow some misalignment.
YouTube
Just make some cuts with a dremel and soften the plastic with a heat gun so your limbs will push threw before hardening.
Attachment 349636
Could make a guide slightly bigger than pipe vs using a hinge with the correct profile. Then could use a dremel with an aggressive bit or an angle grinder.