Printable View
I have a Helix 12 SI Chirp, a I-link Ultera, Transom 360 and an 1199 all networked together. Only have one ducer and it is on the transom, use the 360 most of the time.
Helix is on the bow and when I go to my network options DI and SI are not options, only 2D, Advanced, 360, Temp 1, Temp 2 and GPS. Need help getting the SI and DI options to pop up.
Thanks in advance guys!!
The Advanced tab is for SI and DI.
Got the advance turned on and it only shows the 360Quote:
Originally Posted by Greenwing
Under the advanced tab is the transom transducer not showing up?Quote:
Originally Posted by Rees Guide
No sir, only the 360Quote:
Originally Posted by Greenwing
Ok, don't think I can help. Maybe Rickie will see this.
Thanks thoQuote:
Originally Posted by Greenwing
Before you get upset and throw it in the lake, I will give you 250.00 for it.
Are you a member on Bass Boat Central? There is a few guys on there that could help.
No thanks, I got offered 300 for it the other day so if it comes to that I will go that route!!!:RoflQuote:
Originally Posted by wilbur
Are the 2 units sharing waypoints? .... wondering if they are seeing each other on the network. Does the 1199 have the most recent software?
Does it see the 2D transducer from the 1199 in the network config?
Send Rickie a text he can help you out.
Looked at the 1199 and they aren't showing up on it either, fixing to restore factory defaults and start overQuote:
Originally Posted by ccollins
Maybe try connecting the 2 units directly to each other to see if they see each other that way ..... resetting defaults is a good idea ....
It sounds like an Ethernet cable or the AS ETH 5XPG is not letting the units see the transom xducer ...
Bob has good advice of connecting just 2 components with 1 Ethernet cable to try and narrow down which data travel route is not allowing "data travel".
Rickie.