Has anyone figured out a way to do this? The xi5 does not have a slot in the shaft. The gearbox is in the way. I'm sure someone has a solution.
Printable View
Has anyone figured out a way to do this? The xi5 does not have a slot in the shaft. The gearbox is in the way. I'm sure someone has a solution.
Attachment 258244Attachment 258244Cornfieldcrappiegear.com cable saver'RQuote:
Originally Posted by justatrollin
Two suggestions. Both from C.C sponsors.
First is:
Cornfield Crappie Gear
Second is to not mount the transducer on the TM at all but use this:
Da' Ducer
The pictures are of a MK unit but we have this set up for the Terrova, Ulterra , Ultrex, power drive, and the moto guide Xi5
The hose now only comes in black.
I went with Cajun Fryers cable save'R on my Ulterra. Working great. https://uploads.tapatalk-cdn.com/201...f756c34597.jpghttps://uploads.tapatalk-cdn.com/201...f756c34597.jpghttps://uploads.tapatalk-cdn.com/201...7e9b19e80c.jpg
Sent from my iPad using Tapatalk
Thank you all for the replies
justatrollin,I HAVE A XI5 AND I USE TO HAVE DI ON TM ,THE WAY I DID IT WAS I USE A DOG RETRACTER THAT WOULD ALLOW FOR TM TO PULL CABLE WHEN IT TURN AND WHEN IT TURN BACK THE RETRACTER WOULD PULL ALL SLACK OUT OF DUCER CORD,NOW I MADE ME A BRACKET AND HAVE IT ON A POLE THAT I CAN TURN TO SEE THE FISH ,THE DUCER WILL TILT UPWARW WITH A TURN OF A HANDLE,BUT THE DOG RETRACTER SHOULD DO FINE
How would one thread the transducer wiring through the polly tubing???? The connector is way larger than the tubing opening.:juggle
The tubing is split ...Quote:
Originally Posted by Jigsoaker
Rickie
I just clicked on those links,above.I didn't no they were charging so much for there setups.:yikes:yikesQuote:
Originally Posted by Jigsoaker
...just get you some air hose (there's different colors you can use,also)before you split it. draw a straight line along the inside.the length your going to use.theres no need to run the transducer cable,all the way up to the control head of trolling motor.