Printable View
Had it mounted atop Rickie's da ducer stick. Now I have small dc motor near the top of the da sducer, so I am now in distress without the Point 1.
Need a solid mount with at least 18 inch height. Ideas requested. I cud make somethin, but I druther buy it and save the hassle.
Draw me a sketch Tom ...
I'll build whatever ya want ...
Rickie
I dont know what I want. Suggestons? I need to be able to remove it though. Be nice to run cable inside a tube and out the bottom.
How about the upper 18" of the da'ducer apparatus® shaft ...??
The VHMW top cap of the shaft is already designed for the GPS puck ... and the cable can indeed be ran inside the shaft ...
http://i477.photobucket.com/albums/r...s/IMG_6330.jpg
I just have to design the base ...
Curious why you need it removable ... ??
Rickie
Looks good. Need exit hole at bottom for inside routing of puck cable. The cable connector is small, but it is a molded end, so the bend radius is a factor for cable exit. How to deck mount it?
People steal. My boat stays @ dock on the lift 24/7 - fish time. I remove most electronics when we are not at our lake house.
What about a base similar to the spyderlocks or even a dovetail ?
spider lock base would work. I do not have a lot of room. I guess I need a picture or some measurements.Quote:
Originally Posted by ShowmeCrappie
Here is how I exited the da ducer apparatus with the LSS1 and LSS2. Did the hole with my dremel and side cut bit. PIA.
http://i188.photobucket.com/albums/z...ps22aa66fa.jpg
Does your specific rod holder brand have a removable base design that I could build at the bottom of the GPS pedestal ...??
Then your specifc rod holder brand base plate (that screws to your boat deck) could be used ...
Rickie
He don't sell piece parts.Quote:
Originally Posted by rnvinc
Very well. I will make something similar that leaves a simple base plate attached to your boat deck ...Quote:
Originally Posted by Cane Pole
Rickie
Call him. Bet you get one in the mail.Quote:
Originally Posted by Cane Pole
Doug has an extra HiTek base ...
I'll just make the base of the pedestal fit that ...
Rickie
That is fine Rickie. Mail me the bill.
Cray, all I got one EZs webpage was error 404.
Sent you a PMQuote:
Originally Posted by Cane Pole
Hey Tom ...
Where do you want the hole for the cable exit ... ...
http://i477.photobucket.com/albums/r...psyraoeubx.jpg
Rin
Left side of bolt using this view.
Very well ...Quote:
Originally Posted by Cane Pole
Rickie