I am moving batteries to the front storage area on a recently acquired Pro Team 185. The wiring harness from rear to front TM plug is 6-awg; I have 8-awg on hand, will this be sufficient for the distance of 5 feet?
Printable View
I am moving batteries to the front storage area on a recently acquired Pro Team 185. The wiring harness from rear to front TM plug is 6-awg; I have 8-awg on hand, will this be sufficient for the distance of 5 feet?
I would stay with the 6. Less current loss.
I HAD a similar situation a week or so ago. i moved my batteries up front and got exactly 5 ft from batteries to t/m. i have two batteries in parallel goin to a 55# power drive v2. i called minnkota and they told me size 8awg was plenty big enough from that distant. the original wires going from plug into the t/m were actually smaller than a size 8awg, i would guess it was a 10awg. first time out i trolled for five solid hours, non stop, at 1.5-2.0 pulling cranks before they gave out. now, if you have a 24v t/m i don't know if that would make a difference or not. good luck, ws
I will be getting the 6-Awg tomorrow and installing charger.............thank you!
If you have trouble finding the,ends for 6 gage wire, I finally found some at a local Rural King farm supply retailer. Might try a store like.that.
Where in the store did you find them? I have looked all over the Main store here in Illinois with no luck. I know that some rural kings are not connected and carry some different stuff.Quote:
Originally Posted by cevans
I found them in the battery section next to batteries. The have 1 gage wire for hooking up batteries and ends hanging on pegboard.b. They are the kind you have to crimp. I took a dull flat punch and crimped them a couple of times that way with a hammer. Works perfect and wire is crimped solid. They are solid copper.
I went to Rural King and picked up 4awg pos/neg 72" and a 12" 4awg. pos. jumper in the automotive section.I have everything wired up in series for 24.1v and charger tested out at 25.6v ; just need to mount it and connect in line circuit breaker.
.
Your local NAPA store should stock everything you need for the installation. Both of my stores do.
Thanks; everything charged up great @ 29.2v output on charger need to install a 60amp breaker as opposed to 50amp to protect the 24v system @75lb TM.
A big thanks to everyone for the info and suggestions; system is now complete and functioning properly.