Printable View
I'm remodeling a pan fisher boat and took the live well out. Don't care for them. Any simple ideas to fill the drain hole and aerator holes besides welding? Was thinking a couple aluminum squares bolted over the holes and them some JB Weld along the seams. The holes are like 1 inch of maybe 1 half.
Thanks
Two round aluminum plates a bit larger than your hole.....two rubber pieces same size ( could it out of old inner tube) Drill hole in center of each aluminum disc and also the rubber and bolt through the middle That way you dont have to make any more holes in the boat.
hmm....good idea. Thanks!
I think with G's idea you would need 2 piece's for each hole. One inside, one out.
Exactly......thats what I meant
Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
I have done several like that....put a little silicone on each side of rubber pieces just for good measure. Works great
Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
I used the round plug that has a small T handled that turns to tighten, must admit it leaks sometimes and I re-tighten. Did not want to permanently seal in case I need for trade dollars.
Go to the parts house and ask for temporary expanding freeze plugsQuote:
Originally Posted by 27458
Got a question for you since you took your livewell out. I have the same boat and was thinking of turning my livewell 90 degrees and place it flush against the right side of the boat. How are the holes in the floor placed and would this be much of a problem?
You don't need to bolt or weld.....Simply cut a patch out of a piece of aluminum a couple of inches larger than the hole. Sand the area and the patch with rough sandpaper or a wire brush on a power drill. Wipe the areas with acetone or lacquer thinner to remove any grease or oils, and apply JB weld to the patch, push down and place weight on the patch. Go under boat and smooth out the JB Weld before it starts to set. Wait 24 hours, then hit the water.... She ain't gonna leak there, It's a permanent fix. Did this in transom floor of my Duracraft seven years ago.Attachment 236709
Ok. Thx
How big is hole? Have you ever seen rubber freeze plugs? All parts stores have them. Buy for hole size insert and tighten nut to expand
Sent from my iPhone using Tapatalk
Didn't see Goodtimes postQuote:
Originally Posted by torch
You'd just have to adjust the houses running to the livewell is all. But I'm trying to remember. I think it was welded or maybe the drain pipe was secured from under the floor so it might not be as easy as it looks. You'd have to take the floor up one way or the other though to adjust. I use a cooler and ice anyway so it was just in my way. I like my fish cold when I get back to clean.Quote:
Originally Posted by mitrisin