What do you use to clean the screen of your sonar units?
Printable View
What do you use to clean the screen of your sonar units?
I know H'bird recommends Windex vinegar glass cleaner
Usually just water and a microfiber cloth ... but, I have used "computer monitor cleaner".
... cp :kewl
Windex with vinegar and a microfiber towel.
Touch Screen = 50/50 Alcohol, Distilled Water mix, Non Touch Screen 50/50 Vinegar, Distilled water mix. Micro fiber cloth a must for any screen cleaning
70% Distilled water, 30% White distilled vinegar and a few drops (depending on size of spray bottle) of Dawn dish washing liquid. Shake well before every use.
Gota have a washed micro fiber cloth.
I think it's best to stick with the Windex Multisurface With Vinegar for the Humminbird units to prevent any possibility of damaging the coating on the screen.....and a microfiber cloth works very well.
Amazon.com: Windex Multi-Surface Cleaner, Vinegar, 26 Ounce: Prime Pantry
If there are some bad spots just put a paper towel over the screen and soak it with the Windex for 15 minutes or so and then wipe with the microfiber.
X2!Quote:
Originally Posted by BobB
I have the touch screens I will try it out.
I cleaned a HB unit will my cleaner for my glasses years ago and it messed up the screen. I think the windex vinegar would work. Thanks
My thumb and some spit
The below is in the FAQ on the Humminbird web site:
How do I maintain my unit?
Your Humminbird unit is designed to provide years of trouble free operation with virtually no maintenance. Follow these simple procedures to ensure your Humminbird continues to deliver top performance.
•If the unit comes into contact with salt spray simply wipe the affected surfaces with a cloth dampened in fresh water.
•Do not spray wash your Humminbird or run through a car wash
•Do not use a commercial chemical glass cleaner on the lens. Chemicals in the solution may cause cracking in the lens of the unit.
•When cleaning the LCD protective lens, we recommend that you first use a solution of warm mild soapy water (like a non-abrasive liquid hand soap or Dawn liquid dishwashing soap), wipe the face dry and if water spots remain, use a solution of water and vinegar. Always use a soft cloth.
•Do not wipe while dirt or grease on the lens. Be careful to avoid scratching the lens.
•Chemicals like sunscreen and bug spray can cause permanent damage to the special coatings on your protective lens. This is not covered by warranty.
•If your boat remains in the water for long periods of time, algae and other marine growth can reduce the effectiveness of the transducer. Periodically clean the face of the transducer with liquid detergent. Pivoting the transducer up in the bracket may allow better access for inspection or cleaning.
•If your boat remains out of the water for a long period of time, it may take some time to wet the transducer when returned to the water. Small air bubbles can climb to the surface of the transducer and interfere with proper operation. These bubbles dissipate with time, or you can wipe the face of the transducer with your fingers after the transducer is in the water.
•NEVER leave your unit in a closed vehicle or trunk - the extremely high temperatures generated in hot weather can damage to the electronics.
I used Windex Multi-Surface with Vinegar for a longtime and always had problems getting the water spots off. I now use 70% Distilled Water / 30% White Distilled Vinegar on my non-touch 998/999 and I think it works a lot better than the Windex. Like IceNitro stated above but without the Dawn, I may try to add a drop or two in my next bottle.