Printable View
I have a 30 cavity 2" grub mold. and i have been seeing pits or holes just in the bodies worse at bottom than the top. I have tried plastic from 310 to 360 doesn't seem to make a difference. cleaned the mold heated it up still the same thing. This has not happened in any other of my molds and cant figure it out. Does anyone have any ideals?? thanks
Sell me your 30 cavity mold anger problem will be solved you will have no more bubbles:biggrin before you start to feel your molds shoot little bit of plastic out first and then shoot your mold.Quote:
Originally Posted by slabeye
Apply constant pressure after the injection for 10-20 seconds and see if this helps. It does my Willow Tail and Thump It grub molds that like to get pits in the bodies.
Worm oil the mold and it will shoot easily
Thanks
If your problem is with pits in the body then it has nothing to do with air bubbles, and you should never have to lubricate an aluminum mold. Try shooting the mold very slow, it should solve your problems.
Yes that could be one of his problems.Quote:
Originally Posted by Angler's Choice
Quote:
Originally Posted by slabeye
Quote:
Originally Posted by snake River
I would say by reading his post that it IS his problem.
One thing for sure is to let us know what worked lol.
I will let you know what works.
Angler choice shooting it slow worked thanks.
Thats great to hear.Quote:
Originally Posted by slabeye
Good to know. Will have to shoot slower on my grub type body molds.
Yup will try that too if I run into problem
Hey Anglers choice. Welcome from Alabama. That was great insight you had. I am looking forward to reading more of your comments.
Mike