Printable View
I got everything hooked up but I can't get the Bird to recognize the I pilot.
I followed the instructions, tried Ipilot powered up before the bird,bird powered before the I pilot, remote on/off, foot control hooked up/not
I posted on the electronics board too.
Any one with an idea?
You do have the ipilot link? Latest version on all software?
Are you running through the 5 port switch or straight to the unit?
Just trying to help, no implications made, of meant .
Ulterra with I pilot link,
Only the bird and the I-pilot in the system
I got it new on Friday
I need to get an SD card to see if any updates are avaiilable
Got the ethernet cable connected from the troller to the bird???
What HB unit are you using?
The 999i hd si
Yes, the ethernet cable is hooked up via an adapter cable from Humminbird
Cables slipped together easily and screwed together .
I wonder if the bird has
I followed they test instructions to see if it was connected, it wasn't, but they don't have instructions on what to do if they aren't
There is an update, register your link and your 999 and it will give you the updates you need, also giving you instructions to load it. If that doesnt work then I would call Humminbird, may be a communication problem with the 2.
There was a software problem with the units and the update is a must to keep your bird from locking up so it needs to be done anyway.
I would do the update also. Then call HB! I am using the 5 port hub so I am not going to be much help,
OK I got updated and now it is connected to the I pilot, Thanks for you help.
Next question is where to find updates for the I pilot?
I didn't find them on the HB site
Again thanks for the help,
Grady
I think if you registered your i-pilot link with humminbird you should be able to see the update once logged into my humminbird.
My ipilot link shows up right with my HB equipment on the HB page. You do have to click on add new equipment and put in the serial #.Quote:
Originally Posted by midcarolina
I got it registered, and the updates for the HB done now I need to put it in the water to load the MK updates. It says you need to deploy the motor to update, on the toon I can't do that on the trailer
I loaded the updates for the Mk and the remote on the same sd card I hope that works ok.