Printable View
A new issue is popping up! When I inject my molds with chartreuse to cut body section out add primary color I'm getting huge voids in 1/2 of the 12 baits. Could I be sucking air past o rings? How often do you change? I'm going to take off end of injector and fill. ( I know) dangerous and try and see if it's a air issue? I think it is? Have ya'll had this happen to you? Lot of time put in then disaster! Here are some that came out ok?
Are you leaving pressure on the injector after injecting??? I do a 5 count at least after injecting before I take pressure off injector and remove from mold. I then top off mold with plastic after removing injector. Doesn't require much pressure. Too much and you'll run into other problems.
DrNip thanks im not keeping pressure on mold with injector for 5 count I am topping off..thanks I'll try that. I have had many come out perfect then last night 2 major failures...frustrating when I only have 30-45 min. in my man cave in the evenings before she says something? like id like to see your face sometime today!
Lol I can relate.
Is it happening at the end of a color run? I mean is it happening trying to get the last bit out of a Pyrex? You might wanna try pushing alittle plastic back into the Pyrex before injecting molds, this will force the air out.
no its happening on the first shot...ill have two small cavity molds ready that a injector full is more than enough plastic for both molds and 2 or three cavities in each mold will be empty or partially filled. I tried holding pressure on it for 5 count then only one cavity was effected.Quote:
Originally Posted by Percidae_Papermouth
How hot is your plastic? Do you pre-heat your molds on initial shoot?
plastic at 315-325 but I have not been pre-heating . I stopped doing that and now it just hit me! that's it!!! pre-heating I usually heat in toaster at 200. I"ll start over that s itQuote:
Originally Posted by DrNip
Since you are doing two color baits, it might be possible you are covering the areas to vent the air.
I have a couple molds that if I get it too tight and shoot the second color, it will pressurize and not let half the cavities vent leaving unfilled cavities but mostly big air bubbles big enough to make the baits useless. Pretty much right where the tails start. I had to keep tightening with less and less pressure until I found the sweet spot where I could get the air out and still not flash.
Wow crappie farmer on the mo magic mold there is a clamping issue first shot if not clamped tight the tails run so I'll try backing off pressure of clamp on second shot
Can be a variety of things and sometimes each mold likes different things from plastic temp. To clamp pressure. Once you figure it out, shooting gets a lot faster.