Tangled rods rigged for Spider Fishing

Morning All. What is your secret to prevent all your rods rigged up for spider fishing from tangling up in your rod boxes during transportation? Thanks in advance for your tips.

Transport racks.

Rod transport rack Attachment 152299

How the heck do you make a new post/thread

Bombthreat, First you have to be signed in. Check at the very top of the page and you should see a welcome if you are signed in or a place to sign in if you are not. To start a new thread, go the the La. or any other forum page and at the top on the left side there above "forum Louisiana" will be a black button titled "Post New Thread". Click on it and a new page will open where you will put your title and below that your post. I hope this helps.
"gene"

Click on new thread... Believe it's on the top left o the page.

I want one of those racks , who sells them ?

E-Z Poleholder on the MS board makes and sells them them......he has a new model out now.....Check out his ads in the sponsor classifieds or send him a PM

Thanks

Don't break your rods down. Just bind em together in groups of 4 and lay em in the bottom of the boat. Lot less headache than using a rod box. And use a small piece of Velcro for the top end of your rods.

http://www.ebay.com/itm/PLINE-NEOPRE...item3a8c0b2f15

Ha ha.....and dont step on them.....been there and done that lol....thats why I have the transport racks. I also stand them up in stand up rod racks when moveing from one fishing spot to the other. Attachment 152329

This tip will help a little bit. 1) hook your jig down by the reel if your pole has a place otherwise hook in lowest rod eye.
2) run your hand up the line from your jig as far as you can reach 3) Pinch the line(that runs from rod tip to jig) and pull it away from the pole (line should form a "V").
4) hold pinched line in one hand and twist the rod with the other hand.........when line is tight to pole, loop the pinched part that is between your fingers over a rod eye.

The line will wrap tight to the pole in between the rod eyes.
when ready to fish, pinch the wrapped line from rod eye and reverse process.

Rod racks. Attachment 152331Attachment 152332Attachment 152333
You can also break the rods down and put them in stick jackets.

Crappie Nibblet ---- :welcome to the best Forum of all the states... Others from all over the country check in regularly to find out what is going on in Cajun Land. As soon as others see this is your first post , you will soon have the warm welcome everyone gets ---- Watch out for Vet--- he has a Fishing Addiction --- :fish

Some of us tie on more than one Jig . A roll of good Electrical tape will secure loose Jigs and line. Never use cheap tape as the glue will sometimes come off -- Goo ... If tape is used make a tab folded on the stickey side to remove it easily

I use the small size ladies hair clips that you get at walmart.....gety a pack of 8 for a couple bucks.....works great

Welcome Nibblet, it's a good place to be. Why don't you start a thread and give us an introduction to yourself. We like to know the who, what, and where about our friends.
"gene"