Never been to Enid so how about some directions or GPS cord. Tks
Chairman, Tri State Crappie Anglers
Driftmaster's Pro Staff
Printable View
Never been to Enid so how about some directions or GPS cord. Tks
Chairman, Tri State Crappie Anglers
Driftmaster's Pro Staff
Exit I55 turn left, pass the hatchery take left at intersection, continue till you see sign for ramp turn right, nuttin to it.
From Grenada, go North and from Sardis, go South hehe
Has anyone checked on electrical power for the scales, tables and somewhere to sit during the weigh-in?
If all else fails I have a inverter we can plug scales into.Quote:
Originally Posted by yikess
Chairman, Tri State Crappie Anglers
Driftmaster's Pro Staff
We need some recon by a local so we can prepare for the conditions before we leave if need be. They very well could have everything we need but it would be nice to know before we get there.
I can run by there in a little bit if you like.
Yes please, and thanks.Quote:
Originally Posted by Rees Guide
Headed that way
Sent from my DROID2 using Tapatalk 2
Good eltricity, 6 tables but they are chained down so not much moving em. If some have got those 10x10 pop up covers might be nice to have a few of them. Parking will be in the regular lot for the ramp.
Sent from my DROID2 using Tapatalk 2
I have a ez up canopy I can bring.Quote:
Originally Posted by Rees Guide
Chairman, Tri State Crappie Anglers
Driftmaster's Pro Staff
Quote:
Originally Posted by Gator_1
Long as it don't have to Gayder on it LOL
That will help Gator or n
Sent from my DROID2 using Tapatalk 2
Thanks John.
It also has a cleaning station.Not sure if its open due to water level but bring yo knife just in case it is.Thats if you have any keepers to clean.
It is open Canebraker.
Watch for signs guys and you will get there no prob, baitshop on the left as you are coming in from the interstate just before the last turn into the ramp area.
So just take the Hatchery exit, meander through the hatchery area and turn left onto co road 38 (dam road) then up on the left, the bait shop is there. Then up bout a 10th of a mile on the right, turn in and follow the signs to wallace? Sound about right? I'm looking at google earth and trying to figger it out
Dats it, just follow da "me-andering" signs!!:biggrin
Some of them maps don't show it right. Get off at the exit by the hatchery. Go east to the dead end. Turn left and follow the signs to Wallace Creek. Even WB can't get lost.Quote:
Originally Posted by DonDon
I see two ramps on the map. One close to dam and one you drive thru campground to get to. We're going to the one you drive thru campground.... Right?
Chairman, Tri State Crappie Anglers
Driftmaster's Pro Staff
Dont worry bout power for the scales, I got a 1000 watt inverter in my truck.
Sent from my SCH-I500 using Tapatalk 2
We're going to the one with the big arse sign that says "Wallace Creek Boat Ramp".Quote:
Originally Posted by Gator_1
I'm telling you to leave those maps alone. One of them shows the road ending at the hatchery and not even going to the dam.
Reese Guide found it by himself. Just saying.
There is tricity there Sat, its on too, did a Torch Test.Quote:
Originally Posted by satdoc1
fixin to say we can plug it into ole Torchs you know what and I bet it'd have enough juice left in it after all he went through last week with that Lektricity
Thought I had been TORCHED a little while ago by a lightning bolt, hit about 200 yards form me.:yikes
Dats close enough right there John
It was WAY too close!! Didnt argue with HIM, just went back inside.