Ok this is probably a dumb questions but I have had a complete

loss of how to do this, I have a Ego Reach, me and Olebigun kept gettting the cranks caught in it yesterday due to the fact that it is the rubber coated and not the full rubber net. I called and ordered the full rubber one that is suppose to be the thing for cranks. I was told how to take the net hoop off the pole and have gotten that done but I cant for the life of me figure how to get the net off the hoop since the hole that the net slides over has both end coming out of it. I guess its a brain fart or sumpin but I dont see how to do this removal with out cutting the net and I would like to save it if possible


thanks

Larry

Attachment 94186

It has to come apart some where... That's how mine is... But mine is not ego... Just trying to help.

Member, Tri State Crappie Anglers

I have the loop/net part off, it has a pin that connects it to the handle, just trying to figure out how to get the net off the hoop part with out cutting it, dont know if it can be done or not but I aint smart enough so far to figure it out


Larry
[

Call ego they are nice people willing to help

Sent from my SGH-T989 using Tapatalk 2

Piece of cake, Larry. There is a plastic pin through the black yoke where the wires go into it. Push that pin out and take the plastic retainer out of the front. Then you can take the hoop off. Took mine apart so I'd know. I looked at mine for a few minutes before I saw the plastic pin.

Quote:

---

Originally Posted by jigflinger

Piece of cake, Larry. There is a plastic pin through the black yoke where the wires go into it. Push that pin out and take the plastic retainer out of the front. Then you can take the hoop off. Took mine apart so I'd know. I looked at mine for a few minutes before I saw the plastic pin.

---

I have the hoop off of the handle, Im trying to figure out the way to get the net itself off of the hoop now that I have it off the handle, thats where Im running into the problem :(

This may help, Larry.

Sent from my MB860 using Tapatalk 2

Quote:

---

Originally Posted by jigflinger

This may help, Larry.

Sent from my MB860 using Tapatalk 2

---

yep, got all that apart, it the net coming off the hoop after I have it off of the handle that has me stumped :(

You have to walk the net around the hoop in one direction. It's tight, but it will go. Be patient.

Quote:

---

Originally Posted by jigflinger

You have to walk the net around the hoop in one direction. It's tight, but it will go. Be patient.

---

k will give it a try

Push one side of the net onto the loop. Pull the other side down. Take one or two of the net loops off of the loop. Then repeat going the other way. Back and forth a few times until you can pull all the net off at once.

Remember how many loops on each side of the net you removed this way. Cause that will be your starting point on the new net.

Larry, push the hoop wires together and push the net down both sides so the net is all on one side, then slide it off either side.

Thanks all, got it, had to work it around slowly but it did come off, now ifn I had my other net to go back on I would be in bizness :)

Since the rubber net is round bottomed, you don't have to worry about spacing. You can't put in on wrong.

Don't say that .