Anybody know anything about it? Are the kits worth the $ or am I better of having it done?
Wannabe...
Printable View
Anybody know anything about it? Are the kits worth the $ or am I better of having it done?
Wannabe...
There not bad--I've done it on a couple of cars. Problem is it don't last as long as you would think--maybe a couple of years then you gotta do it again.
Least that's my experience
Kits work. Follow instructions and let Ba do it
Sent from my SCH-I500 using Tapatalk 2
Buy new one cheap skate
Sent from my SGH-T989 using Tapatalk 2
The kits work......It will take longer than 5 minutes though, lol
I did my wifes and they looked worse after than before. Vim lazy tough and prolly didnt do it right.
What? You gonna polish up your little girl truck?
i tried it without success...won't do it again
I always trade for a brand new truck before my lights get dim.......get a better trade in that way also
My daughter's headlight lenses were oxidized pretty bad and her boyfriend bought one of those kits and I was surprised how much they cleared up. They didnt come out a good as a brand new one but that much money wasnt spent either. Frankly, I wouldnt bought the kit thinking it was a waste of money and wouldnt work but it was definitely worth the money spent. I guess it just depends on how good you want the lenses to get whether you buy new lenses or try the kit on what you have. I guess Amy's lenses restored to about 2/3rds of what brand new would look like.
Guys...just use Turtle Wax buffing compound...works great and cheaper to if you already have some! put some all over light and use a drill with buffing pad....buff until its like you want it. Been doing it like this for a while at the shop.
wet sand with some 1000 grit paper and then go to 1500 and finish with some 2000 grit and she will shine like new money. Now if head light is leaking (moisture) inside then some of the dullness is inside the lens and nothing that will get it.
There pretty cheap
Jewler's rouge works good, too.
This. I used a grinder with a buffing wheel. Be very careful if you use a grinder, it can be too fast and WILL melt the plastic if you really bear down on it. Like mentioned before, it won't last long. I polished mine a couple of times (96 Dodge) and eventually just replaced them. Should have done that in the beginning.
If you go the buffing route, wax the fool out it afterwards. It will help the polishing last a little longer.
Auto lights are made with cheap polycarbonate. They could use carbonate with a UV film that would keep'em from darkening with age. I've used carbonate for years in the boat industry, and I always specified using UV protected material. Maybe using it would make cars too expensive.