off the motor and check for any fishing line that might be present, On my Honda I just used a adjustable wrench to take the prop off but I see "prop wrenches" and was wandering if I will need on for this motor since its a Mercury ? as I said might be dumb question, so go easy on me :)
I wouldnt think so, use an adjustable on mine but its an older model.
I just use a deep well socket and keep it in the boat.
You can use an adjustable or a socket just like you always did......no need for a prop wrench.
Thanks guys, wasnt sure on this
thanks again
Larry
Larry.....if ya just got to spend some money......go buy a new spinning reel, lol
aint got no money G,dats why I been tryin to trade some baits for one :)Quote:
Originally Posted by "G"
My 90 optimax manual says to torque the nut when you put it back on
Absolutely use a torque wrench. The problem with the plastic wrenches is that while the prevent you from stripping your prop nut off, they also keep you from tightening the nut to mfg specs. I keep the socket in the boat with a cheap ratchet for emergencies on the water but always use the torque wrench to tighten her up after servicing.
I think its and 1 1/8 or 1 1/16 socket.
1 1/16 for most outboards.