Printable View
I bout tired of them being stacked over iin the corner of the garage and need some ideas on HOW to store them out of the way. Recon I got 25-30 rods now a days from 5 foot to 16 foot. Need a way to get them up off the floor and out of the way. Pics are prefered. LOL
Don't have a pic but I mounted rod holders on the ceiling of my garage. Inexpensive and outa the way. Easy to reach from in the boat as well!
I got two 2x4s and drilled holes in them and put 8 inch pieces of dowel rods in the holes at an angle. Then I screwed the 2x4s on the wall of my boat shed about 5 ft apart and hang my poles on the dowel rods. Kinda red neck but it works.
x2Quote:
Originally Posted by JTMavs
And I use to keep them on the wall attached to some peg boards, worked well but wanted my tools there instead.
Anything under 10' goes in a rubbermaid garbage can. Anything over 10' goes on top of the pop up camper. Prolly something cheaper out there than the pop-up, but it dang sure works pretty good for holding rods.
Wannabe...
Peg board on my shop wall. Only 25-30??? Novice!!!rotfl
Or if you got an attic, just sayin.
GOT to go in the garage. The attic is out of the question. That's where Nessa keeps all her Christmas, Halloween and Thanksgiving decorations LOL We have winders on one side of the garage and our deep freezer slap full of crappie on the other wall hehe
peg board and pegs...I like Scott's idea also.
The long rods get stored in my Levi's
BWAAAA HAHAHAHA not what I heard TMan
DD, i took 1/2 in. pvc and made these , i hid the screws by drilling a hole inside to T fitting, and didnt glue them so that if i needed to i could make any of the pipes longer, i know you'll like them because they are cheap to make...lol.
Attachment 78560Attachment 78561
Fantastic idea Mr. Goodtime
I like that man, Sho appreciate it. I got to do something
anytime , if you got any questions , pm me and i'll give you my #
Dont care how they get stored but before i put mine up i clean all of my poles with armour all especially the ferrules,makes the poles look good and they wont stick together.
screw hooks into a 1x2. mounted on the wall. liquid tape for protection in the eyes. L hooks work the best.
Here is mine. Cost you less than $10. That's summpin even WB can live with! http://i393.photobucket.com/albums/p...yslab/rack.jpg
Tman, you banned for 24 hours. I wear wrangler.
I had a buddy at work make mine. Took a piece of 1" flat steel and cut it 18". Bent it at 6" and 4" and screwed 4" side to wall x's 2.
Slimmey, how'd you attach to the ceiling?
I've got 4 sets of these in my shop
Don they are fairly easy to make and not very expensive.
Drilled a hole in a threaded plug(male) and then ran a lag bolt through the inside of it into a ceiling joist.Quote:
Originally Posted by crappiholic
Boy there are some great ideas on hanging them so they would be out of the way.
I have exposed rafters in my storage shed, so just some 1x1's nailed across the rafters, slide the rods in, well protected from accidents that happen in storage sheds.
Seen some pretty good idea's posted....thanks
Sent from my Milestone X using Tapatalk
Do it similar to Slimey's except take a piece of rope and thread it thru a piece of 3/4 PVC. Screw hooks into the ceiling to hang the rope from. No elbows and less pipe. Adjust yo rope to the height you want the poles to be.
Great idea minner. Easy to install. Just need rope pvc n some hooks
and a little duct tape always helpsQuote:
Originally Posted by DonDon