2 Attachment(s)
I was not gonna post this, but...
It may remind someone to be careful.
I got to go fishing at Grenada Sunday morning. The water was at the same basic level as it was this spring, so I decided to go try some stake beds out from North Graysport. I put in at South graysport and run under the bridge and get about to the Dummy line rd bed and WHAM! the tiller is snatched from my hand and the boat does a hard right. I gather the boat and slow down to a snail pace and check my drawers for...well you know what. Well I was clean, but I got extremely lucky, because if I would have had a partner fishing, he/she would have gotten wet for sure. If the boat had kicked left instead of right, I would have almost for sure gotten wet. I had my life jacket at my feet and not hooked to the kill switch, the last place it needs to be in an emergency situation. I was almost over confident in my abilities on Sunday. If I would have gotten thrown my boat would have had to run in circles until it crashed into another stump/ rock/ god forbid someone else, or at best run out of gas before I could have gotten back in it. So this is just a reminder to wear your kill switch and your life jacket. Just because the motor is only a 30 horse, things can still happen. Just because you have fished a lake for a while and know it well, does not mean a tickers damn, accidents still can and will happen.
I proceeded to fish for a couple more hours, but got no bites. I put-putted to Buttputter creek to try to catch something, but it was too shallow. I then put-putted back under the bridge and went north and since it was out of the wind, I gapped her wide open to see if I may have hurt something in the lower unit. It ran great just like always.
I get the boat out and load it up and I see this when I am putting the transom saver on...
Attachment 71312
Attachment 71313
I see that there is a forearm size chunk of cast aluminum knocked out of the fin. What can be done to fix this?
Chilly
