y'all know how I should remove a lowrance transducer that was epoxyed onto the hull at the factory? I hate leaving it there, I want to sell the X135 units after I insatll my new Humminbird stuff.
Printable View
y'all know how I should remove a lowrance transducer that was epoxyed onto the hull at the factory? I hate leaving it there, I want to sell the X135 units after I insatll my new Humminbird stuff.
I believe I would just leave it there. You would probably have to destroy the transducer to remove it anyway as it would probably have to either be cut or ground off and you might damage the hull in the process.
I'm gonna sleep on it, but I do think I will just leave it in there. Unless one of y'all come up with a better plan>>>>>>>>>
I dont know how to remove one from a hull but I seem to have a knack for removing mine from my trollin motor.
Only way is if you have enough clearance to smack it solidly with a hammer. A big hammer preferably. The impact will crack the epoxy. No worries about damaging the hull though. The tough part is cleaning up the area for the next install. chances ate, the diver is toast. But sometimes you get lucky.
Wannabe...
That was funny Kydo.:D
WB, does IS know you are up this late??:eek:
MAJ. THOUGHT SOME ONE SAID THIS WHAT TIME OF NIGHT HE IS DOING HIS RIGGING ON HIS NEW BOAT,,,,BETTER HOPE THOSE SUPPER DISHES ARE DONE AND PUT AWAY THOUGH:oQuote:
Originally Posted by majflyboy
A SHARP WACK WITH A HAMMER SHOULD DO THE TRICK AS SOMEONE STATED,,,
Now you can see why Wannabe takes his boat to a boat mechanic....he always wants to hammer on something.
or drill holes!
All jokes aside a flat chisle and hammer should do the trick, Ive used a screw driver/hammer combo before and worked great
I'm not sure but DD can help you install your new one ifn you are a bird watcher.