Today was quite an adventure, two 4 yr olds on a boat w/ a sugar high
http://i143.photobucket.com/albums/r...bluegills1.jpg
Bout 15 fish most gut hooked needless to say, but a good time had by all.
Big
Printable View
Today was quite an adventure, two 4 yr olds on a boat w/ a sugar high
http://i143.photobucket.com/albums/r...bluegills1.jpg
Bout 15 fish most gut hooked needless to say, but a good time had by all.
Big
Sweet memories......keep it up they will luv you even more when your in the rocking chair,while they teach your grandkids what you taught them.
That will never happen, cuz in my house we only have 2 rules that are set in stone.Quote:
Originally Posted by Fishn N Wishn
Rule #1: no tattoos
Rule #2: no dating
til daddy's dead, so far it's working out very well. Then again she's only 4
Big
Was my #1 rule for years. But as my daughter & stepdaughter turned 13 few months past,I'm thinking only way to mantain this is kill the boys.then I'm in jail and them 2 wins but other 3 kids loses rofl.Them girls sure has their ways of making daddies eat crow for sure :D My 7 y/o girl has a ways to go.But damn if the older girls isnt making a good example of what not to do :D :DQuote:
Originally Posted by stinkies daddy
stinkies daddy and all other that have the same problem.
This is what I was instructed to buy before I started fishing in the south (1967). I was told that the bream needed a "special tool" to help remove the hooks. I have not been without it since.
http://i171.photobucket.com/albums/u...r/DSCN2642.jpg
I have talked to several friends that fish for bream and told them about the special tool I use, and have been playing around making a few.
http://i171.photobucket.com/albums/u...r/DSCN2643.jpg
As you can see my "special tool" is made from a small screwdriver. I have tried several different screw drivers and they all work very well. The most readily available screw driver that works well is an Xcelite # R184.
http://i171.photobucket.com/albums/u...r/DSCN2644.jpg
I heat the end of the screw driver and make the bends, then take a file and create the notch in the flat.
When using, you push the notch down into the curve of the hook while holding the line taught. Hold the tool so that the offset goes against the barb of the hook. Just push down until you can feel the hook come loose then gently pull tool and hook from fishes mouth. This should lessen the results of a normal gut hook.
I lost one of my homemade versions while juggling a bream and trying to pickup the tool. Sad to say overboard the tool went. Now I have attached a cord and have it attached to my flotation vest, THAT I WEAR WHEN EVER I GET IN A BOAT.
Flycaster are you offering to make me some of those cool tools, i really dont trust myself around power tools right now. heres what i mean
http://i143.photobucket.com/albums/r...drillthumb.jpg
To be completely honest .................................................. . this sucked very much bad
You didn't have to post that, I looked at the post just after breakfast sunday morning. UGH :eek: :eek: :eek:Quote:
Originally Posted by stinkies daddy
no screw drivers left in stock.
flycaster
Hemostats also work well.
To hold the cut together????? :rolleyes: :rolleyes:Quote:
Originally Posted by crappielimits
Just had to ask