What are you fellows using for a stand up rod holder for livescoping, I would like to have one for taking off fish, changing baits, switching rods and maybe just moving from one place to another. Any suggestion appreciated.
Printable View
What are you fellows using for a stand up rod holder for livescoping, I would like to have one for taking off fish, changing baits, switching rods and maybe just moving from one place to another. Any suggestion appreciated.
Pappy suggested a project using PVC. If you’re using Millenniums they have this add on. Pricey though…
R-102 Rapid Rod Transport - Millennium Outdoors
On my rod holder T-bars I attached some 3/4" PVC 4-ways between the rod holders using hose clamps. I bored the vertical holes out with a 1" bit and spray painted everything black to match the rod holders. Here's the fitting I used...
Attachment 458065
I do have the millennium rod holders, so it may work, but the holders are in the way livescoping. I will look at it thanks.Quote:
Originally Posted by BuckeyeCrappie
There is also this…
Site Maintenance
Made ma one today, I have the versatrack on my boat so I went to Lowe’s and bought a piece of 1 1/2 inch pvc and cut it about 6 inches and drilled a hole for it to fit the versatrack and put a 1/4 inch screw in and tighten it up, works like a charm. Thanks buckeye for giving me the idea under site maintenance.
I ordered the millennium holders as I have their rod holders. When spider rigging, you need some where to put a rod while rebaiting or taking a fish off. I always found I would lay the rod down on top of one of the other rods, and no doubt would get a fish on one of the rods I was crossing over. Yes they are pricey. But I find everything to do with fishing is pricey. Everything is pricey this day and time. I do not intend to transport the rods in a standing position although I have seen people that do. I use the drift master rod holders for transporting.