Printable View
Haven't been on the water, finally got a appt with a neurologist to see if my meds needs adjustment,. But let's see if I can get the bunks recovered today on for the toon tried yesterday at the boat ramp yeah �� too dam staples. So a it's parked at a neighbor dock.
Attachment 427163
And if I get that done I'll try and tackle putting this on today..
Attachment 427164
Wish me luck..
Ok yall pull all the staples out or pull what you can , then pound the break offs back in the wood to rust out??
This is soo freaking tedious I'm just 36 inches in 1 16 ft board an got 4 boards ��
Think someone had carpeted this before with comerial style , has like a backing to it just falling apart as I'm pulling it.
Guess all the staples and the weight of the pontoon was holding it on .
Those staples arent any fun to put in or take out. They do make a staple puller that works pretty well.
Got my lineman pliers an needle nose so not too bad
Just got 1 board striped , guess the garmin not getting installed today .. I need a break any ways got to replace the short lag bolts holding the lumber into the frame. Luckily the white Jones carries lots of stainless steel fastners..
Attachment 427178
This is on the back underneath see all the staple holes there were more staples on the stacked carpet on top of that.
I'm going to let the wood dry out tomorrow, i tested it it's solid.
After it's dry I'll put Thompsons on all of them put the marine garage bunk carpet on it, the new led lights then the trailer will be done..
Ugh, that’s a lot of work. GL with the finished product.
Got all the carpet off an staples out at 6pm I'm done for the nite..
Attachment 427183
If yall think this needs to be moved to the main forum go ahead an move it wasn't thinking..