Printable View
I'm thinking about trying to build an independent mount for my mega live to go on my ultrex using the same mount/bracket that the 360 uses. I have a template to cut out from aluminum but wasn't sure what the thickness was, whether it's 1/4 or 3/8. I have looked at just buying the mount/bracket but haven't had any luck. Would anyone either have the thickness or a place to just buy the mount?
Sent from my SM-S215DL using Tapatalk
Pictured below is what I'm trying to replicate. It's actually a motorized diy project but I plan to build as a manual twist pole that will raise and lower with the trolling motor.Attachment 424234
Sent from my SM-S215DL using Tapatalk
I used 1/4”
Attachment 424263
Sent from my iPhone using Crappie.com
Pm sentQuote:
Originally Posted by Redge
Sent from my SM-S215DL using Tapatalk
Pm answeredQuote:
Originally Posted by huntersdad
Sent from my iPhone using Crappie.comAttachment 424343
The HB 360 Ultrex bracket kit is a pretty expensive item ...
https://humminbird.johnsonoutdoors.c...0-hardware-kit
Of course it has both pieces of the bracket where you may only need the flat plate for your application ...
Rickie
I plan to purchase .25 steel plate to build the bracket from. I'd rather do aluminum for longevity but I don't have the ability to weld it. I'll most likely have to weld in a section of 1.25 pipe and an angle brace of some kind. I did notice the price of humminbird bracket and that's why I plan to diy it. It's very pricey for what it is.
Sent from my SM-S215DL using Tapatalk
That’s why I did my own. To expensive for what it is.
Sent from my iPhone using Crappie.com