Printable View
I just installed the AS GPS HS on my boat. I'm currently on the water testing and I and not getting the heading line on my map unless I disconnect the link from the unit with the Link cable connected I'm only getting the green line and I went into the network setup and have the external GPS antenna selected
Sent from my SM-S215DL using Tapatalk
I was able to determine that if the trolling motor is off the heading sensor works as it should but as long as the trolling motor is powered on I only get a single green line which is the same lion that you get if the boat was in motion without the heading sensor installed. When sitting stationary I am getting the boat icon instead of the donut. When I deploy the trolling motor then I get the green purple and black line when moving
Sent from my SM-S215DL using Tapatalk
Seems as if the terrova gps is becoming primary as long as it is powered on. Attached is the accessory test. Attachment 411101Attachment 411102
Sent from my SM-S215DL using Tapatalk
https://youtu.be/VFA0mObeAP0
You may have to set the User Mode to Custom under the Setup tab to see this option ...
Rickie
I have heading line selected. I will get a heading line as long as the terrova is powered off. Once I power on the motor the heading line goes away.Attachment 411152Attachment 411153Attachment 411154 the first picture is with motor off, second is motor deployed on trailer with prop off.third is with motor on but stowed
Sent from my SM-S215DL using Tapatalk
I’m out of ideas .
Try Restore Defaults ...
Rickie
I requested a call back from humminbird this evening. I will post what they say.
Sent from my SM-S215DL using Tapatalk
I got a phone call back from hummingbird this morning, as of right now they have no idea and don't know how to even answer the question so it's getting pushed to a higher department and then they will get back to me
Sent from my SM-S215DL using Tapatalk
Try disconnecting the iLink from the Network and see if the unit will actually show heading from the AS GPS HS antenna ...
Rickie
I did try this yesterday, and when the ethernet cable is disconnected then I will get the heading line from the as gps puck. Also when the trolling motor is stowed and powered off I get it also. When the trolling motor is powered on but still stowed, the heading line will go away as soon as the banner says ipilot link connected. Yesterday, each time I wanted to operate the boat using the external heading sensor I had to stow and turn off the trolling motor then power on before deploying again. I talked to humminbird today and was told my issue would have to go to a higher tier tech and would be in contact. The lady asked if I was on the latest software for both devices and I am. She also told me to restore to defaults. I did this tonight and still no change. As for now the only way to use the as gps with the link is to unlink it from the hummingbird which defeats the purpose of having the link in the first place.i also confirmed that I am subscribed to the as gps in the network tab.
Sent from my SM-S215DL using Tapatalk