I recently lost a tm prop half way through a day trip. That has never happened in my 50 years of boating. Have any of you used low/med strength thread lock on the prop nut?
Sent from my SM-G960U using Crappie.com Fishing mobile app
Printable View
I recently lost a tm prop half way through a day trip. That has never happened in my 50 years of boating. Have any of you used low/med strength thread lock on the prop nut?
Sent from my SM-G960U using Crappie.com Fishing mobile app
No, I just torque mine down good and never a problem.
Besides, every year or two I take mine off to remove the "Bird Nest" of mono twisted up behind it.
It was REALLY bad a couple of years ago.
And yes, I check behind the Mercury prop too, for the same reason.
Those are held on by a lock nut. After taking them off and on several times the Teflon locking part wears out . I put a new nut on mine if it comes off easy. It should come off tight all the way.
Sent from my moto g(7) power using Crappie.com Fishing mobile app
Oh duh... forgot about being a locknut [emoji15]
Sent from my SM-G960U using Crappie.com Fishing mobile app
I wonder if the pin came out allowing the prop to spin against the nut twisting it off the shaft.
Nope. Pin still intact :scratchhead
What kind of fastener was was you using to tighten the prop down?
Either the prop threads are stripped or it was pilot error.
Sent from my E6910 using Crappie.com Fishing mobile app
That is definitely oddQuote:
Originally Posted by silverside
The tool that Motorguide supplies with the prop. It was tight. Been on there for 2 years before coming off.Quote:
Originally Posted by catchNgrease
Sent from my SM-G960U using Crappie.com Fishing mobile app
Is this tool plastic?
Sent from my E6910 using Crappie.com Fishing mobile app