boat id stickers

Does n e 1 know how to get the dadgum id stickers that you get at a hardware store off of the hull. I work with vinyl graphics and even I dont know a secret to do it

Try Goo Gone from Wal mart. Or Goo Off. They work good on stuff like that.

WD-40 also works good to remove stickers and residues.

Ditto on WD-40 or similar product. Or acetone, mineral spirits, lighter fluid, gasoline....be careful

Heat gun or hair dryer to start with and then a solvent for the adhesive. Barsol Automotive Parts Cleaner does a good job and it's not too hard on your hands.

All of the above should work. But keep in mind what type chemicals you rub on your boat if it is fiberglass, and what it could do to the finish coat.

I've used a hot water power washer to remove those several times and it works better than anything. Solvents will only remove the glue but you have to get the vinyl off first. There is also a flapper wheel made by 3M called scotch-brite molding adhesive and stripe removal disc Part #07502, but it can burn the paint finish if your not real carefull with it. I still think the hot water power washer is the best. If they aren't real old and dryed out a hair dryer or heat gun will work though if you don't have access to the other stuff.

I would probably go with them boys that already posted...I was going to mention you could pay me $20.00 and I'd do it 'fer ya, but it seems with all the good advise they've already given you, I'd take the FREE advice, haha! When I seen your boat saturday at 6 a.m. it appeared you already had them off!!!! Good work! MM

ok there sob's are 23 yrs old and the only way i found to do it is a razor blade and a very steady hand, there comming off but my fingers are killin me