Printable View
My engine runs than kills, the bulb goes soft and when pumped up sounds like it is pumping air back into the tank. I changed the conection between the hose and tank cause i found a cracked O ring. Tried a different hose, it ran fine then started the same problem. I'm thinking water in the carb before I go in to them, wich would work best Sea Foom or B12 Chemtool MEK.
Water in carb wouldn't cause that problem. If it sounds like air going back to tank it would be check valve in bulb bad. Still sounds like you have a air leak in your system somewhere. Pull cowl off and pump bulb. Look for air bubbles or fuel leak around all lines and connections under cowl around motor. Also recheck that oring inside connector that attaches to motor.
As far as Addative Seafoam is best.
Wow you were right on top of this THANKS i'm checking that now. Hope to see you at D'Arbonne Gathering.
Seafoam
Seafoam only because I’m familiar with it, and because Cray and G said so.
Sent from my iPhone using Crappie.com Fishing mobile app
Its good fer yaQuote:
Originally Posted by Redge
X 2 ------> seafoam
Neither product will remove water from the fuel.
What Cray said...Quote:
Originally Posted by Skippa Chippa
Sent from my VS986 using Crappie.com Fishing mobile app
I was hoping someone would say it! These products are designed to keep fuel FRESH! A fuel/water seperator will remove water.Quote:
Originally Posted by sliderman