I had this hanging round and I'm sure someone needs it for their fishing rigs project,,, willing to part ways for something of equal fishing junk value,,,
Printable View
I had this hanging round and I'm sure someone needs it for their fishing rigs project,,, willing to part ways for something of equal fishing junk value,,,
Still available,,, this one has low miles on her,,,nThe guy bent his trolling motor shaft after about only two months of use,,, so it's in great working order,,,
What is that
Sent from my SM-G930V using Tapatalk
No but I can draw you up one.
Sent from my iPhone using Tapatalk
What model make trolling motor do you have?
Trim tab. I cut a piece of aluminum 2"x4" and mounted it in the picture location. It does not have to be perfectly centered with the shaft. As long as the the tab is basically parallel to the motor housing. I pop riveted the trim tab to an aluminum rt angle piece and used hose clamps to clamp it to the shaft. I notched out the ends of the angle so I could clamp it to the shaft. This is what they do to ships and boats with bad behavioral problems. My pondtoon has 2 trim tabs from the factory. Behavior modification.