Printable View
Wondering if anyone had any tips for the correct mask needed when pouring plastic molds. I have a N95 but not sure if it is the correct one. Any suggestions would be helpful.
Ps this stuff is addicting
https://uploads.tapatalk-cdn.com/201...5d0dcdbf69.pnghttps://uploads.tapatalk-cdn.com/201...d8f582cd2c.png
Sent from my iPhone using Tapatalk
Want some type of organic vapor respirator. Cartridges only last like 12 hours or so I believe. I did a thread here in this forum on a cheap exhaust system that works wonders.
I used the respirator mask that you find in the paint department of Lowes, Walmart, or any other good hardware store. Welcome from Alabama. Great job.
Here is another thread on ventilation that might help you some.
Mike
http://www.crappie.com/crappie/diy-s...1=#post2329498
Here is my thread on the fan. I have my jig baking oven right under it so that it gets my Pyrex cup full of plastic right under it. Only time my plastic isn't under it is when it's in the microwave or being poured in my injector.
http://www.crappie.com/crappie/diy-s...1659-vent-fan/
In doing some research HazMat Classification B for personal protective equipment is for use with the plastic we all use. This means a SCBA respirator should be used at all times. These are way more expensive than any mentioned previously. Most start at $250 and go way up past $3000. Anyone use on of these?