SI and DI transducer on same unit
If I were to take the DI transducer from my old 570 DI and hook it up with a splitter cable to my 598 SI would the DI view on the 598 actually use the DI transducer or would it still be using the blended signal from the standard SI 'ducer that came with the 598? I'm not sure off the top of my head whether the 598 is using the 455 or 800 frequency on the SI. I'm pretty sure the 570 was 200/800 with the DI. I"d have to check on the specs of each to see if there is a common frequency between the 2.
If it won't work with the 598, would it work with a higher end unit like a Helix 7 or 9 SI? Would you have to specify in the setup menu every time you went to the DI view from an SI unit? I would think if you had a switch it might work as you'd only be getting one signal at a time.
Too much time on my hands today, I guess........
