Printable View
I am planning on putting out some crappie beds soon. I am going to make them out of pvc. I have heard that pvc can be hard to find in the water. I know a lot of you fishermen have come up with a way to make pvc more visible under the water and easier to find on your graphs. Since I promise not to steal the locations of your beds could you give me an ideal of how to sink mine and easily find them next time I look for them.
Dont make them easy to find....
Good electronics and marking your waypoints and your secret is golden! ;)
Here's one out of fiberglass.
Attachment 240437
Fill these pvc attractors with concrete for max visibility.
If stealth mode is what your after tie them to a concrete block instead.
https://youtu.be/Qlx5nt_lfFc
Sand the pvc and mark it with GPS it will show up if I was u I would also make some out of wood stakes I think they like wood better I like to mix mine with the pvc and wood
Anything hollow...I.e.- bamboo or pipe is much tougher to locate through sonar.. Like Slabin said mark it with GPS
Sent from my iPhone using Tapatalk
All I can say is I've sunk pvc structures and I absolutely can't see them with down scan or side imaging. I thought trapping air inside the pipes would make them visible, but not the case for me.