Weedless Pony Jig Head

I hope Do-It is paying attention as they need to expand their crappie weedless jighead line!!!!!!!!!!

Here is how I mod my pony head to a weedless.

1st take off the wire hanger that comes standard with the mold. To date I've had no use for it except this. I cut a straight piece off of the wire and line it up on the mold where I want my fiberguard to rest.

Attachment 206895

Once lined up in the mold where I want it, I close the mold and squeeze as hard as I can until it puts an imprint into the mold where I want to cut the fiberguard.

Attachment 206894Attachment 206893

I then hook up this attachment, found at your local Lowes or Home Depot, and set the depth to the same depth as the Do-it weedless mold fiberguard. The bit is also found at Lowes or Home Depot and is about 1/16" wide.

Attachment 206897Attachment 206898

Take your clamps and clamp on mold so that the Dremel bit lines up with the grove cut into the mold.

Attachment 206896Attachment 206899

I then run the Dremel tool back and forth until the proper size grove is met. This usually takes a bit as you will need to put a fiberguard into the mold and cut until it closes properly.

Attachment 206900Attachment 206901

And the end result is this. Enjoy.

Attachment 206902Attachment 206903

Man, Nip you have way more patience than I do. You do some fantastic work.

Thanks for the post Doc. very informative.

As always too notch

Very nice Nip!!

Nice mod - could you use the teflon pins to do your pours then powder paint and just glue them after??

FMan do the teflon pins work well? What glue do you use to put the fiber in with? Sorry Nip, don't mean to hijack, but curious minds want to know!!LOL

I don't know if the Teflon pins they sell come this small. The ones I saw were bigger for bass jigs.

Think you just use superglue Kirk.

Here is a statement from Barlows about the Teflon pins they sell.


"Teflon pins are available in 2 sizes. 1/8 for use in molds that use fg-30 fiber bundles, and 5/32 for use in molds that use fg-40 fiber bundles."


Need to find a smaller pin for FG-9 and 12 guards. Looking at McMaster Carr the Teflon pins only come in 1/8" and higher. The heat tubing Barlows sell is for 1/8" and bigger. Maybe wrapping guards in a thick aluminum foil will work??? Maybe just need to find something, a rivet pin or whatever and use it for a pin. Spray it with some casting release and then pour the lead. Will add this to my "To do list".

DRNip,

Posed the teflon pin size for the 9 and 12 fiber guard to a buddy of mine on another board. He makes his own for the fg-30 and 40. He may know right off what size bar to get from McMaster Carr or if someone carries them. I'll let you know.