Printable View
Ok I have issues with my mold only when placing tails in the mold and injecting the bodies. Only on the left side bottom two cavities do I have issues with. The body will only fill half way just like I was laminating. The result is a tail with only half a body down the middle. I have tried worm oil and sometimes it works and then not. The mold is warm. Any ideas. It is a mo magic mold. I sure wish they would come out with a tail mold.
It would look like this bait but with out the brown side. This is taken from dr nip as an example
Attachment 202785
When your injecting its probably pressure on your clamp. When it's too tight no way for air to escape ? Causing voids
Makes sense as that is where my clamp is on that side. Thanks will try a lighter clamp pressure. I have been clamping it pretty good. I would know when it didn't fill good as I would see air bubbles come up the spru. That must be from the air not vented.
I guess my question would be do the molds only require one clamp on the open side?
If you're doing half a bait in one color, make sure the side open for injecting is the side with the vents cut into it.
CTom not trying to pour one color lol. Just came out that way