Spinner Jig Head

Can you attach a crane swivel with the blade of choice to make his head a spinner? It says the 2nd loop is for a stinger hook.

Thanks

yep I did it look in the forum pages bait saver jigs

Where did you find the head or the mold at, if I may ask? You could also attach a willow or Colorado blade to the lower hoop via a split ring. Check out Zeiners for some great prices on them.


Bobo

You may wanna watch using then, because when I did the barrel swivel an blade swing up next to the body and doesnt spin very well at all. This was just my experience with it. The bottom eyelet is used for a stinger hook.

That's a do-it mold. Live bait jig. Zeiners has it.

So it is a heavier jig?

Bobo

I want to say my mold has 1/16 cavity on up to about 1/2 or 5/8.

Quote:

---

Originally Posted by Bobo Greybeard

So it is a heavier jig?

Bobo

---

1/16 1/8 1/4 3/8 1/2 5/8

I played with my mold a little today, going to paint and tie some now and see how they look in the tank.

I think a tiny micro swivel with two very small split rings would just fit with the 1/16 and a #4 hook. Here is a picture without the swivel and you can see it still looks a little short. This is with a standard RR blade off an old rusty RR I had.

I cut off the little collar on the jig with a pair of tiny wire cutters. After painting, eyes, and tied, it weighs in at 0.069 without the blade and a #4 hook.

http://i97.photobucket.com/albums/l2...psb85364fe.jpg


I really like the head design, I'm going to pour some without the stinger eye.

I don't know if this would work for sure but i think it is worth a try. Put the split ring in like you have it then attach the swivel another split ring then the blade. Looks like it would drop the blade enough so that it would work. :twocents