Printable View
Well I went ahead and bought a cc mold and medium injector. I used it once I got it but didnt clean or lubricate the injector or mold after I used them. I went to shoot some baits today and noticed some pitting or staining in the mold. The baits look good so I dont believe its pitted. I was wondering if I need to clean both the mold and injector, what would Iuse to clean it with and what is recommended to lube the injector and mold.
shoot a pm to Snake River. I just have an aluminum injector and I use either my fingre or soft ag to remove excess little bits of plastic.
you want to clean your injector every time that you shoot a mold if you're having problems with the baits sticking you can spray Pam on them lightly just make sure that all your tools and objectors are clean before you reshoot make sure that your molds are cleaned also if you're wanting to clean your injector inside spray some Pam inside of it and run the plunger back and forth. I occasionally do this to start out with one smiling injector is hot I don't worry about it but just make sure that the plastic that is left after you shoot is pulled out of the injector.
Pam spray, I'll do it. I wouldn't have thought to use that. Thanks for the tip.