Printable View
I am not as good at wiring as I wish I was. I just bought the HB 596c HD DI at Basspro and I have a 2000 Crappie Pro 175 that came with a HB 100sx.How much rewiring will I have to do to get this puppy onboard and working? I can easily pull through the transducer but wiring power etc is where I get nervous. Am I over worried or should I get the scuba gear out before I drown? Any tips or advice would be greatly appreciated.
Terry
I would start by trying to use the power cable from the 100SX. If you start having power related issues I would see about getting a new set of wires to run from the new power cable all the way back to the cranking battery (through a 3-amp in-line fuse of course).
Thanks Greg! I was wondering if they were standard. Awesome. I looked at the connections on the HB site in accessories for it and it looked like a sandard for power. Also what are the extra connections for? I think I read 1 is for speed/temp. Is that right?Quote:
Originally Posted by Humminbird_Greg
Speed/Temp and the other is for factory testing.
Thanks Greg For the valuable insight. I was a little jumpy at first but I think I'll install on Saturday and test on Sunday. Week after that I am on KY Lake!:ThumbsUpQuote:
Originally Posted by Humminbird_Greg
I just got done installing the same unit on my boat. Everything went very well. The instructions are pretty intimidating! You shouldn't have any trouble, The only issue I am having with my unit is I hooked the power cable to one of the trolling motor batteries, I wouldn't recommend that. First trip out to the lake every time I would push the button on my trolling motor it would make a line as wide as the time I was pushing the button. I have since routed my power wires to the cranking battery in the back and haven't had any interference or problems, Hope this helps!
Thanks for the tip. Got it installed and to starting battery! all appears good.Quote:
Originally Posted by blackriver4x4
Good deal, I hope it works out for you.