Tilt /trim cylinder leaking any suggestions rebuild or replace.
Printable View
Tilt /trim cylinder leaking any suggestions rebuild or replace.
As long as the shaft is not scarred, I'd say rebuild. I had to rebuild one on a 40 Yamaha quite a few years ago and that held up fine. Then again, if you are needing a reason to get a new motor...........
Rebuild kit almost 80$ went to John deere got square o-ring 1$ not leaking yet
Yer killing our profit margin!!! BWAHAHAHAHAQuote:
Originally Posted by JJohnson
Big River Marine
Bill Burnett
870-635-0202
We offer Xpress, Excel, and Alweld Boats. Yamaha, Suzuki, Evinrude, and Tohatsu/Nissan Engines.
Pro Staff, Southern Pro Tackle and Ozark Rods.
Member, Tri-State Crappie Anglers
I'll give u a call if this don't work. thanks
Poor boys got poor ways! :twocents Glad you egineered a fix without bailing wire or duct tape.:biggrin
Yea it seems to be fine I stalled it at top and bottom several times. time will tel. thanksl
I do hope it works for ya. It should!
Big River Marine
Bill Burnett
870-635-0202
We offer Xpress, Excel, and Alweld Boats. Yamaha, Suzuki, Evinrude, and Tohatsu/Nissan Engines.
Pro Staff, Southern Pro Tackle and Ozark Rods.
Member, Tri-State Crappie Anglers