I'm looking at a used Bear compound set. It has a draw of 60#. Can it be adjusted to 30/35#? If so, I'll need instructions. I'm getting it for the grandkids for a super good price.
Printable View
I'm looking at a used Bear compound set. It has a draw of 60#. Can it be adjusted to 30/35#? If so, I'll need instructions. I'm getting it for the grandkids for a super good price.
just come down on the limbs bottom them out and you should have around 40# or so
One turn on the limb bolts of most bows equates to approximately 3 pounds of draw weight. So to go from 60# to 30# you're looking at around 8 to 10 complete turns out. That's an awful lot. Don't know if that would be safe. Best thing to do is call Bear Archery and ask. Better safe than sorry. Good luck.
Sent from my MB860 using Tapatalk 2
Cain, just be sure to back it off the same amount, full down backing off on the top and then the bottom. Do it a couple of turns and then check it, doubt you can back the screws out too much but it will get less accurate once it gets out sweet zone.
It's really not a good idea to try and back it off that far
Do not do it. I had a bow shop ,and there is not a bow made that has that much adjustment. Very dangerous.
Sent from my SPH-D710 using Tapatalk 2
Ok, some good advice viewed by me. My grand daughter needs a left handed bow with a 30/35# draw. New bow alone at Sportsmans is $225. On craigslist, I found one, with 10 arrows, practice and blade tips, a few tools and a hard case for $75. I talked to him, said it had a 60# draw.
I'll call Bear monday and see what they say.
If possible take it to your local bow pro shop and make sure the limbs are not cracked and string or cables are in good shape. Sometimes you are money ahead to just buy a new one. I would not buy a bow that I have not had inspected by an experienced Bow tech. Just my two cents.
Most bow shops will make adjustments for free its a good idea to have one look it over