Transducer Shield and Saver

Just purchased a transducer shield and saver for my Hummingbird High Def. SI ducer. The shield is very well made but will not fit on my Minn Kota Edge trolling motor. Not enough room between the fin on the front of the motor and the prop on the rear. Don't think I can modify it and make it work.

Anybody else had this problem? Suggestions?

Joey, Check out the similar threads on bottom of this page.They should work for you.

Used a dremel to cut off some of the bracket on my 70 lb Edge , Fits just fine now . I mean off the ducer shield LOL not too much leave enought room for the clamp .

Scap makes a plastic spacer for the Edge that will go between the shield and the motor housing. It moves the shield just low enough to clear the prop.

Give him a call.

Brian