Eagle Classic Power connection
I have a problem. The power connection on my Eagle Ultra (10-15 yrs old) became loose so I wiggled it to see if it was loose. It came apart in my hand because the rubber connector was so rotten. The wires are still on the female pin connectors but I don't know which pins on the depth finder to put them on. I am only using 2 of the 6 wires and only for the power. Does anyone have one of these that could tell me which pins I should put the power on? If I connect it to the wrong pins, it could ruin the unit and it was working perfectly until the connector came loose.
Eagle Ultra Classic connections
Looking at the back of the unit the pins are starting on the top one as number 1 it looks like the power wires go on number 3 and number 6. I cannot tell which is hot and which is ground as mine is all still in a harness and plug. This is the best I can come up with!! This is counting in a clockwise direction.
Ulotra classic Power connection
Quote:
Originally Posted by
Kissimmee Kowboy
I will probe that connector today with a multimeter and find out which place is the hot pin. I will also look in my junk for a power connector. I will get back to you after I do some checking
I did check this out and this is what I found. Looking at the back of the unit and at the receptacle for the plug. the alignment arrow is pointing to the right. Start with top pin being number 1 count clockwise and the # 2 pin is the hot the # 5 pin is the ground. That would make them come out side by side the way you said you thought they were. I looked and I don't have a power wire for any eagles left. All I had was a couple of temperature sensor cords. Good luck with this and good fishing
Jim R