Printable View
I just changed the shaft in my Minn Kota trolling motor its a All Terian 70 lb with 24 volt. The old one was bended. I got it changed out put a new one back in motor assembly. But I have a problem the motor turns backwards. Can this be reverse some way. I put the new one just like how the old one came out. I`m a little confused.
Double check your wiring. It sounds like you reversed the + and the - wires.
I'm with IBN.
Could you not change the wires at the plug? And let it run the right way with that? I know I wired the plug backwards one time on a Johnson 12-24 and it ran backwards in forwards .
Pete
did you take the bottom half apart? if you got the magnet backwards or upside down it will spin backwards too!
if not you got a wire backwards... I rebuilt that exact same motor and had the same problem.....
The magnut could be backwards. I`ll take it apart again and see if I see anything wrong Thanks for the ideas.
Aekhoff you was right on the money magnet was on upside down. Turn it 1/2 turn put it back together works like it should Thanks for the help!!!!!!
Hey....glad you got it fixed.....I am going to remember the advice you got here...just might come in handy some day.