It's easier to put the plugs in from the outside of the boat. Stick the plug in, twist till it's pretty snug, then flip over the handle.
Printable View
It's easier to put the plugs in from the outside of the boat. Stick the plug in, twist till it's pretty snug, then flip over the handle.
FYI...I would re-think using one of the "flip-over" style drain plugs installed on the outside of the boat. Seen 2 disastrous results with them getting pulled out while on the water. Use the "t-handle" style that tightens by turning if installing from the outside.
Gman
Each time I read of all the "fun" that comes with boat ownership, I'm just a little more convinced that being without a boat is a blessing.
If it's not one, it's another.:mad:
Yea, but Sink, look at all the fun your missing out on!!!
Hi all! We are going back to the T-type screw in plug. Haven't had a chance to take the boat out since the last leaking incident. Maybe when it gets cooler. We've been busy getting our house ready to sell so we can move to Eufaula area. Then school started so no more time for fishing anyway. Hope everyone is keeping the sun off their brains!
Peke
Good to see you on here Peke, been awhile, was wondering about you!!!