Wall ideas for shop?

Quote:

---

Originally Posted by Will_P

The only time I have seen plywood warp in a shop was when moisture got involved. My buddy's shop would condensate so bad that the floor and the walls would be wet. He installed a vent fan in the attic part on a timer, it kicks on twice a day for 15 minutes each time. He no longer has an issue wth the condensation but his plywood has warped.

---

When they poured the slab did the concrete guys install a vapor barrier, plastic sheeting under the slab?

I doubt it. He bought the place with the shop/airplane hangar already there. It was probably built 20 yrs ago.

My first reaction is ..."Why is that shed so darn CLEAN?"" You got WAY too much time on your hands......

Quote:

---

Originally Posted by Iwannafish

So. I now need to "finish" the inside walls of my pole barn. Thinking plywood on bottom 8 foot, galvanized to ceiling. My question is this. I have 2x6 first on 30 inch centers. If I screw 1/2 inch plywood to them, will that be sturdy enough, or will the plywood warp over time? Do I need to install 2x4 stud walls first? https://uploads.tapatalk-cdn.com/201...1e5f8606f6.jpg


Sent from my iPhone using Tapatalk

---

i think you would have a ton of waste if you used plywood straight to the 2x6's. if it were me i would frame out in between your posts then wall it up. my stepdad has a shop built exactly like yours and thats what we did with his. the post jut out about 2 inches but it gives it a good look. we used 1/2 inch bead board. its cheap and fairly light i did his entire 40/40 shop in 2 days by myself.