Arkie cranks depth chart!

[Crappiemaniac]

Sent from my iPhone using Tapatalk

[Crappiemaniac]

Sent from my iPhone using Tapatalk

[nccater]

[QUOTE=Crappiemaniac;3314508][IMG]http://uploads.tapatalk


What speed and line diameter?
I think this is for 20 lb braid (6 lb mono equivalent).
How would these numbers change with 10 lb diameter?

["G"]

[QUOTE=nccater;3356614]

[IMG]http://uploads.tapatalk


What speed and line diameter?
I think this is for 20 lb braid (6 lb mono equivalent).
How would these numbers change with 10 lb diameter?

Not much......i run 1.6 to 1.8

["G"]

Pushing is figured with line at a 45 degree angle.
Pushing or pulling line out is measured from where the line enters the water

[Rees Guide]

Pushing (weighted) the line diameter does not make near the difference as it does pulling. Ready for an Arkie pulling chart to be available

["G"]

I got a thousand of them John.....its on the back of my cards

Sent from my SAMSUNG-SM-G891A using Tapatalk 2

["G"]

Sent from my SAMSUNG-SM-G891A using Tapatalk 2

["G"]

Tested with 20 lb braid and 10 lb. Mono

Sent from my SAMSUNG-SM-G891A using Tapatalk 2

[nccater]

Pushing is figured with line at a 45 degree angle.
Pushing or pulling line out is measured from where the line enters the water

So if I need to let out 15 feet of line to get my crank down to 6 feet, I basically let out 15' PLUS how ever much it is from water line to my rod tip?