LOST SIGNAL on MINNKOTA IPOLOT POWERDRIVE V2

[Hawg]

I have a barely used IPilot MinnKota POWERDRIVE V2 that will not get a gps signal. This is frustrating because although I can still use basic features, I cannot use any of the features that make it an IPiLOt such as spot lock, auto navigation, etc. I have checked the wiring and still no better. Does anyone have suggestions for a contact who might be able to assist me with this issue? I appreciate it.

[Cray]

Pull the 4 screws from under the head and remove top cover. In there should be a brown wire with a fuse holder. Pull that fuse and check if it is blown.

[Hawg]

Pull the 4 screws from under the head and remove top cover. In there should be a brown wire with a fuse holder. Pull that fuse and check if it is blown.

Yesterday, I checked that fuse and it looked fine. I'm going to replace it anyways and see if it helps. Thank you for the suggestion.

[Cray]

Yesterday, I checked that fuse and it looked fine. I'm going to replace it anyways and see if it helps. Thank you for the suggestion.

If that doesn't work I would get on the phone to them because I can't think of anything other than that unless the board is bad. And just make sure all the connections are good.

[strmwalker]

Yesterday, I checked that fuse and it looked fine. I'm going to replace it anyways and see if it helps. Thank you for the suggestion.

looks can be deceiving, its best to use a volt ohm meter to check a fuse for continuity !!!!

[jimmydee1]

We recently had a problem with a TM while on the lake. I called Grizzly Jigs, and their guy walked me through a fix. Just a suggestion, that or call the Company. GrizJig no. 573-333-9866.