Surely not at the same time!!!!!!:yikesQuote:
Originally Posted by KDAVID1
Printable View
Surely not at the same time!!!!!!:yikesQuote:
Originally Posted by KDAVID1
Hahaha nope
Bet if I did I could put a 300 on the back
Sent from my SAMSUNG-SGH-I777
That ought to work Don
Well least your boat has had two GROWN men in it.Quote:
Originally Posted by KDAVID1
Attachment 112415
All I need is 3 lilpro rod holders n I'm done, I was bad needing to upgrade but don't have 250-300 to do it. This'll work for a couple years. Soooo much sturdier
I'd have like to have seen Donnie n kdavid on the front of the boat. Bet it was leaning real bad lol
Don,
How did you lock the pipe to the floor base to keep it from twisting?
I have similar base units in the back of my boat. I used a lock nut like they use in electrical conduit, but I have to tighten it with channel locks to get it to stay put. Not a big issue, but it would be awkward to do while trolling or moving on the water? Mine has a piece of angle welded to the top as a cross bar so I can't tilt mine up and down but they sit at a good angle to the water.
I had a piece of angle iron on top before but I had those $7 rod holders n they were always coming loose or I'd have to tap on them to adjust them, got tired of that. I just screwed them into the bases tight, their solid. They ain't going no where
Here's what I had before. Served a purpose but got tired of constantly adjusting them. Attachment 112428
Dang DD, I am proud of you, NO DUCT TAPE in site!