New Rod Rack

Thanks "G", and DD I mounted mine below the pullin rods and the storage rods haven't gotten in the way at all. Maj wanted his higher so he could get into this storage box, not an issue with mine. Good thing is, they are so adjustable and can be added to or changed with little or no effort and the whole thing can be removed with no effort, just loosen the keeper knob and remove it from the base.
Attachment 57076

EZ what size is the up right square tubing?

The stem is 3/4" 16ga steel and the receiver is 1" 16ga steel as well. Standard length for the stem is 18" but can be longer if desired. What you do after you have installed the desired holders, and adjusted the spacing between to your likeing, you can measure and cut off the bottom of the stem.
I'm gonna go to aluminum one of these days, but not in the near future, can't get the cost right at this time.

Quote:

---

Originally Posted by DonDon

I didn't pay real close attention Maj but was thanking. Scary huh? What do you do when you have cranks out with the rods? Seems the one's that are not being used would get in the way to getting your poles out when pulling

---

I put the 6 rods I'm not using in vertical holders (rocket launchers) and they are completely out of the way. Don't have to reach over or under.

Works looks like.

Maj....have you got a pic of your rocket launchers? I would like to see where you located them etc.

Will take a pic for u tomorrow, G.

Thanks Maj

Quote:

---

Originally Posted by EmptyStringer

We're gonna have to talk really soon. Wait.. I guess I'm gonna have to buy more than 4 poles to justify getting the racks. Oh well just more money

---

ES the way he has that setup built you could get one with 4 pole holder then add to it as you add more poles.

G, here is the pic you wanted of my rocket launchers.

Attachment 57180

The two on the left are for the poles, the one on the right is for seat pedestals.