STILL couldn't get the airbrush to do right

[DonDon]

I messed with the dang thing for well over an hour last night and at one point, I had the back off it and was loosening the screws, turn them abit and tighten them back down. Tried everything I could to get it to work. It actually did work for about 2 crank baits, that's it but there wasn't much paint coming out, least then like it was. I even tried thinning out the paint and it still wouldn't do right. Got to do something and was gonna actually TRY and tread the Manual but the dang text was so small I couldn't read it LOL

[DonDon]

Hey Maachuu, what brand is yours? Mines the same and I forgot to write it down

[maachuu]

Paasche

[maachuu]

just read that you need to check that the 3 little holes are open that are located behind the nozzle part and beside the needle itself

m

[DonDon]

Thanks, I'll try that tonight. It's wierd cause when you put your finger over the spray knozzle, air pumps back into the paint bowl so I know that part is clean. See if I can find some troubleshooting info on it

[creekslick]

Put some duct tape on it.:D:D

[DonDon]

Is there a way to increase the air pressure on the compressers? Think mines at about 20 and that's the minimum it's a 1/8th HP

[DoubleGobble00]

I thought somebody said they were running at 35 psi but I am not sure. I am sure the will chime in in a minute.

[Slabo]

spray can at Wally World $1.97 if it clogs up throw it away and go buy another.

[MO' MONEY]

Maybe its just the operator