Re-downloaded upgrade and ran it on both units. They both upgraded to v2.5. SCORE. Can view map card on both units.
Next small problem is the yellow wake up wire doesn't wake up the other unit. Hmmmm?
Printable View
Re-downloaded upgrade and ran it on both units. They both upgraded to v2.5. SCORE. Can view map card on both units.
Next small problem is the yellow wake up wire doesn't wake up the other unit. Hmmmm?
No I don't think it will?it will only work to wake up the Ls box and the like
They told me at bp to putt I like that because it was better. So I did just as told and glued it to lowest point in hull without any air bubbles and let it set for 24 hrs.
Well,, you were given 'BAD':Doh: info. The 'Skimmer' ducer can be glued:ThumbsUp in hull, but NOT nononothe SS. See if you can get it 'unglued'. Then mount it in transom area where it will be in water and without anything out to the sides. I doubt if you break it:dono BP will do anything about it. Sorry <*)}}}><Quote:
Originally Posted by day dreamer
Dammit I will try. They even picked out the glue for me and gave me advise about how to do it.
What Is the glue that they gave you? Brand name and type of Glue? Silicone..... Epoxy...or other?
I will try to determine how to remove it , IF possible without damage to SS module or boat.
What is your hull made of?
It has taken half of today got it and cleaned off stuff very minimal scratches. I now have it mounted on rear of boat ready to try it out . THANKS for the help I hope it works now. I probably better reset cuz I have tried to set it so im sure its way off.
Just 'Restore Faults' and you should be fine. <*)}}}><