Likes Likes:  0
Thanks Thanks:  0
HaHa HaHa:  0
Results 1 to 2 of 2

Thread: Johnson Idling Problem

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 03-08-2011, 10:14 PM #1
    bttmline's Avatar
    bttmline
    bttmline is offline Moderator
    Join Date
    Sep 2004
    Location
    Tippecanoe, Ohio
    Posts
    1,305
    Post Thanks / Like

    Default Johnson Idling Problem

    Ok I did it. I put a 15hp carb on my 2000 9.9. Very happy with the high end speed. BUT, I cannot get the idle down. I have adjusted the idle screw out to where it isn't even touching. If I push on it, it will slow to a workable speed. I will try the cable but was fishing for any other ideas.
    Ohio State Board moderator
    www.easternbuckeyecrappieclub.com
    or [email protected]
    NAFC Life Member
    Reply With Quote Reply With Quote
  2. 03-10-2011, 10:35 PM #2
    bayoumonster's Avatar
    bayoumonster
    bayoumonster is offline Crappie Wall Hanger II
    Join Date
    Jan 2011
    Location
    Rodessa, Lousiana
    Posts
    524
    Post Thanks / Like

    Default

    The reason could be that the idle mixture is too lean, caused by an incorrectly adjusted idle mixture needle, or a dirty idle circuit. Try adjusting the low speed rich/lean adjustment needle counterclockwise, and if that doesn't work, clean the carburetor. The fact that it's a 15carb. shouldn't affect idle as far as I know.
    Good luck,
    JBJ
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

BACK TO TOP