I have not done the reset procedure. On that water, I didn't have to do that. I could turn it off, and turn it back on and it would clear the fault. It's not really a "fault" now. The motor that stows the unit has run in too far. If I knew what made it stop, I could run the bracket back out and have it going again in 20 minutes. I do not see any external proximity switches..... I can take a couple of E clips off, pull the motor off and rotate the "nut" for the acme thread until it's back where it needs to be. My question is, if I do that, is the motor still going to think that it's pulled in too far?